Pairing

The connection between the measurement bracelet and your smart device is established via Bluetooth. Therefore, it is necessary to activate Bluetooth on your smartphone (please refer to the instruction manual of your mobile phone).

The bracelet was sent to you in shipping mode. To wake-up the bracelet, please put it on the charger for 2 hours.

1. Attach magnetic cable to back
2. Plug USB Cable in charger
3. Green PPG LED on back starts to blink
4. Green LED next to pusher starts blinking
5. Full when LED next to pusher is continously green

The polarity of the magnets in the bracelet and the charger will ensure that the charger contacts will align.

Make sure that the charger cable is properly attached, see the movie and images on the Charging Page.

Please start pairing and follow the instructions.

Once the device is found, please confirm by pressing the button. On successful pairing, the bracelet will light the orange LED up for 10 seconds and then turn it OFF.

The app will display the Serial Number found. Please double check the S/N on the device and click Confirm.

You will be reminded to type 999999 (six times 9) on the Bluetooth pairing screen

Please type 999999 and press Pair