The battery life of the bracelet is approximately four days. When notified, could you please charge for four hours.

1. Attach magnetic cable to back
2. Plug USB Cable in charger
3. Green PPG LED on back starts to blink
4. Green LED next to pusher starts blinking
5. Full when LED next to pusher is continously green

The polarity of the magnets in the bracelet and the charger will ensure that the charger contacts will align.

Bracelet is charging when the green LED left next to pusher is blinking. When fully charged, green LED is on continuously until you remove the charger cable.

When you put down the bracelet with charger cable, it can come off easily when not placed flat on table. Contacts come off, but you may think that the bracelet is charging. Please check LED next to pusher, it must be blinking green.

Please check if the charger cable is attached well. Please put the bracelet flat on table (on on its side).

The connection between the measurement bracelet and your smart device is established via Bluetooth. Therefore, it is necessary to activate Bluetooth on your smartphone (please refer to the instruction manual of your mobile phone).

The bracelet was sent to you in shipping mode. To wake-up the bracelet, please put it on the charger for 2 hours.

1. Attach magnetic cable to back
2. Plug USB Cable in charger
3. Green PPG LED on back starts to blink
4. Green LED next to pusher starts blinking
5. Full when LED next to pusher is continously green

The polarity of the magnets in the bracelet and the charger will ensure that the charger contacts will align.

Make sure that the charger cable is properly attached, see the movie and images on the Charging Page.

Please start pairing and follow the instructions.

Once the device is found, please confirm by pressing the button. On successful pairing, the bracelet will light the orange LED up for 10 seconds and then turn it OFF.

The app will display the Serial Number found. Please double check the S/N on the device and click Confirm.

You will be reminded to type 999999 (six times 9) on the Bluetooth pairing screen

Please type 999999 and press Pair

Download & install the “CardioMood Trends” app onto your smart device.

The “CardioMood Trends” app is available in the App Store and Google Play.

Android app on Google Play

Minimum requirements for use of the app:

• iOS: version 12.2 or higher
• Android: version 8.0 or higher

Wearing your bracelet

Tighten the strap so that it is secure against the skin, the green sensor light should not been visible. Your bracelet should be snug but comfortable.

Prevent skin irritation

You may get a minor rash from wearing your bracelet, similar to fitness trackers and watches. While it will likely disappear in a matter of days, there are a few ways to prevent it from happening in the first place.

• You may most likely to experience irritation if you wear your strap really tight, loosen strap with one hole.
• While the bracelet is water resistant, we recommend to keep it dry whenever possible. For example, always take it off when you take a shower.
• We recommend taking off your bracelet after every workout, wiping it with a clean towel, and allowing it to dry while you shower.
• Once a week, take the strap out of the bracelet and wash your strap. You can wash your strap with soap or rub its surfaces with an alcohol wipe.
• Before putting your bracelet back on, apply lotion (for example this one) to your wrist. This locks in hydration and forms a protective layer between skin and strap.
• If you experience redness or skin irritation, feel free to wear the bracelet on the alternate arm so as to not overexpose one skin area. This will not affect heart rhythm measurement accuracy of the bracelet.

Please click on the image to check the full CardioMood Bracelet Instructions